Thursday, May 31, 2007
10-bit send from arduino to max
This is my first Arduino sketch. It reads a 10-bit analog value from, say, a pot and then breaks it up into two bytes and these get sent to Max/MSP where the data controls the frequency of a sinewave. Basic stuff, i know. Below you can see the Max patch and Arduino sketch with comments.
Subscribe to:
Post Comments (Atom)
2 comments:
Nice Post,
I am assuming that MSP/MAX can't handle 10bit data and that is why you split it up in to hi and low bytes. I am using a Pic16f88 which has 10bit ADCs and am having problems getting MSP to see the 10bit data. 8bit no problem.
Max/MSP *can* handle 10 bit data, i believe. But check out the help patch. The issue for me was the Arduino's Serial.print command, which sends data in the form of 8-bit bytes.
Regards
Post a Comment